Friday, October 19, 2012

A Primer on Winching, Part 1 [From Badlands Off-Road Adventures]


Rigging a "floating" pulley. 2nd parachute will be added next.

If you spend any significant amount of time in difficult terrain, you're bound to encounter a recovery situation at some point. It could be either your vehicle or someone else's. And a winch may be the proper tool at that time. This is a good time to review recovery, and winching in particular.
The steps that follow are taken from my nifty and exclusive Winch Recovery Bandana. Keep in mind that these tips and the information provided on the bandana are not a substitute for proper training, sound judgment and quality equipment.
Every winching operation should start with a plan in your mind as to how you'll rig it up. Winching is a risky procedure; proceed very slowly and methodically. You're dealing with material and parts that are subject to a tremendous amount of force. A mistake can be fatal, as I pointed out in "Don't Lose Your Head While Recovering a Vehicle." Take your time.
Winching begins with a walkthrough. You want to inspect all parts and lines while the system is under light tension. If everything looks good, you can power up and proceed with the recovery.
The vehicle doing the recovery is kept in neutral with the emergency brake on. Having the transmission in neutral protects the parking pawl. Chock the front wheels if you can. (Some people even anchor this vehicle to a tree or other vehicle.) You do not want that vehicle to move. Start the winch slowly so you take up some of the slack.
Lines that are slack while on ground take on a new dimension when under tension. You need to check them before proceeding with the recovery. The lines may be binding or twisting. They could be rubbing against an edge on the bumper or other body part. In some cases the lines end up right over a taillight. Under load those lines will smash the cover and bulb.
Check all connections. Start at one end of the line and work your way through. Are any connections about to be pulled through the pulley? Adjust as needed.
Keep the engine running, or its battery will be drained dry. Even though the emergency brake is on, someone should be in the recovery vehicle applying pressure to the brakes. Now review the winch cable as it is leaving the winch. Does it leave at greater than a 15 degree angle? If so, it will start to pile up on one side of the drum, causing the cable to snag and possibly break that side of the winch. If you see the cable starting to pile up, stop winching. Disconnect the cable, pull it out manually, and wind it up neatly. Always start with your cable properly wound on the drum. Then, consider moving the recovery vehicle or pulley to decrease the angle of pull.
When you winch at greater than a 15 degree angle, there's a greater chance of the cable rubbing or getting caught on the bumper of the recovery vehicle. There may be times when you have no choice but to winch at a severe angle. Just watch the cable closely.
As you're paying out the cable, remember the Rule of 5: Keep at least five turns of cable on the drum at all times (eight turns for synthetic cable, because it's slippery). If you don't keep a minimum amount, the tremendous force of recovery will pull the rest of the cable right off the drum.
If you have a large blanket, toss it over the pulley. (See image. ) Called a parachute by 4-wheelers, this blanket will absorb some of the energy should the cable snap.
Keep an eye on the parachute during winching. It has a tendency to ride up the cable. You don't need that jamming into the pulley or winch. Stop the winching if necessary to move the blanket.
Position spotters to watch the lines and pulley. (They should off to the sides of the vehicles. No one should be in the path of the lines.) Winch slowly, and pay particular attention to portions of cables nearest the vehicles. You're watching for any binding, rubbing and twisting. Make sure, also, that the vehicle being recovered is behaving properly. You may need to stop the winching and adjust the whole arrangement.
As I mentioned at the beginning, this is just part of the entire winching process. Next month we'll review the corresponding steps, which take more of a strategic view.
Until then, good winching!

Related Articles from Badlands Off-road Adventures


I hope to see you on the trails!
Tom Severin, President
Badlands Off Road Adventures, Inc.
4-Wheel Drive School
310-374-8047
http://www.4x4training.com
Make it Fun. Keep it Safe.
#####

No comments:

Post a Comment